Linyi Yu Heng Mechanical Chemical Co., Ltd.
Contact: Chairman - Chan Hua -13905390882
Manager - Shang Jun Yu -15376910008
Contact phone: 0539-5778777
Company fax: 0539-5778717
Contact Q Q:948562665
Micro signal: 15376910008
Company mailbox: firstname.lastname@example.org
Company website: www.yuhengjixie.cn
Address: Xinqiao Town, Lanshan District, Linyi, Shandong
According to the introduction of the impregnating paper manufacturer of the polyformaldehyde factory, the preconsolidation degree is the precuring degree of the impregnated paper of the polyformaldehyde manufacturer, and the prefixing degree of the concave and convex is also involved in the quality of the impregnated paper of the polyformaldehyde manufacturers. Therefore, the factors affecting the degree of pre consolidation are mainly as follows:
To a certain extent, the degree of pre curing repercussions the liquidity of the resin after hot pressing. The lower the prefixing degree, the better the mobility of the resin and the greater the amount of shortening. If the prefix degree of the POM impregnated paper is high, the surface of the floor will produce a lot of dry flowers, crack appearance, poor appearance, and so on. And if the POM manufacturer impregnated paper is too low in degree of pre curing, the finished products will be relatively poor in water vapor resistance and heat resistance.
In order to produce high quality products, the dipping paper manufacturers of paraformaldehyde equipment manufacturers must be good at the prefixing degree, as long as this can make the goods go to a very good height.