Linyi Yu Heng Mechanical Chemical Co., Ltd.
Contact: Chairman - Chan Hua -13905390882
Manager - Shang Jun Yu -15376910008
Contact phone: 0539-5778777
Company fax: 0539-5778717
Contact Q Q:948562665
Micro signal: 15376910008
Company mailbox: email@example.com
Company website: www.yuhengjixie.cn
Address: Xinqiao Town, Lanshan District, Linyi, Shandong
The principle of the dryer is introduced by the polyformaldehyde factory.
The liquid material (through filtered liquid) is sent to high quality polyformaldehyde drier on the high speed rotating centrifugal atomizer. The centrifugal force of the rotating disk extends as a film on the rotating surface and moves to the edge continuously. When it leaves the edge, it is atomized and the droplet after atomization (the surface area is greatly increased) is heated with the hot air. Exchange, quickly complete the drying process in 10-30 seconds.
It is important to determine the temperature (hot air temperature) and the outlet temperature (exhaust temperature) of the hot air into the tower in the operation of the spray dryer of the polyformaldehyde factory. The exhaust temperature is related to the moisture content of the product and should be determined according to the moisture allowed by the product. The higher the hot-air temperature, the higher the thermal efficiency, the better the economy. However, too high hot air temperature will result in poor quality of products, so hot air temperature must be appropriately improved under the premise of ensuring product quality.